Output Power : 2W
Size (mm):36.47 × 16.20 × 3.00
SA818S-RX is a highly cost-effective receiver module for professional walkie-talkies. It features a built-in high-speed microcontroller, high-performance RF transceiver chip, and 2W audio amplifier. and provides a standard serial port to communicate with the module, so that the relevant parameters of the module and the receiver can be set quickly and easily. Function to control. Users only need to connect an audio amplifier, microphone, and speaker to this module to work as a small walkie-talkie receiver. The simplified interface and ultra-small size enable this module to be widely used, and it can also be easily and quickly embedded in various handheld devices to improve the overall performance of the terminal product.
SA818S-RX strictly uses lead-free technology for production and testing, and meets RoHS and Reach standards.
Parameters | Test condition | Min. | Typ. | Max | Unit |
Voltage range | 3.0 | 4.2 | 5.5 | V | |
Operating Temperature | -40 | 25 | 80 | ℃ | |
Current Consumption | |||||
Sleep Current | ≤30 | uA | |||
Receive Current (Without Audio Signal) | 68 | mA | |||
Receive Current (With Audio Signal) | External 8Ω 2W Speaker | <400 | mA | ||
RF Parameters | |||||
Operating frequency | 400 | 480 | MHz | ||
Receive Sensitivity | 13dB Output Voice Signal-to-Noise Ratio | -124 | dBm | ||
Receive signal-to-noise ratio | @1.5KHz frequency deviation | 45 | 50 | dB | |
Audio output amplitude | 1000 | mV | |||
Audio output impedance | 200 | OHm | |||
SPK output load | 4 | 8 | OHm | ||
(Above 2 frequency bands are optional,
following frequencies can be customized)
200~260MHz,470~520MHz
Band width 12.5KHz / 25 KHz
Sensitivity:-124 dBm
RSSI Signal Strength Indicator
High-integrated, Small Size
38 CTCSS & 166 CDCSS
Built-In EEPROM For Data Retention After Power Loss
0.5ppm KDS TCXO crystal, Stable performance
small walkie talkie receiver
Invisible intercom system
audio surveillance system
Outdoor Sport products
building community security system


Pin NO | Pin name | IO Level | Description |
1 | CS | 0-5.5 | Module sleep enable: Ground for sleep mode; floating or pulled high for normal operation |
2 | AFOUT | Chip audio output pin. The signal level should not exceed 1V Vpp, and it has no driving capability | |
3,5,8 | GND | Connect to power ground | |
4 | Audio ON | 0-3.3V | Signal Indicator Pin: Low when no signal is present; high when a signal is received. |
6 | ANT | RF input (connect to a 50Ω antenna) | |
7 | VCC | 0-5.5 | Connect power positive |
9 | TXD | 0-3.3V | Serial port transmit data pin Note: In module sleep mode, the user device needs to output a low level to prevent leakage or abnormal reset |
10 | RXD | 0-3.3V | Serial port receive data pin Note: In module sleep mode, the user device needs to output a low level to prevent power leakage or abnormal reset |
11 | SPK+ | External 4-8Ω speaker, 2-5W power speaker | |
12 | SPK- | External 4-8Ω speaker, 2-5W power speaker |


Privacy Policy
· Privacy Policy
There is currently no content available
Email:sales@nicerf.com
Tel:+86-755-23080616