Contact Us
HOME > PRODUCTS > BLUETOOTH MODULES > BEACON128 : 2.4GHZ SMALL SIZE EMBEDDED BEACON MODU...
Beacon128 : 2.4GHz Small Size Embedded Beacon Module
- Beacon128 is a low-voltage, low-power, fully-integrated, Bluetooth 1 Low Energy Beacon Module, It features a low-power physical layer, a link layer with an embedded security engine, a Host/Controller Interface (HCI), and a powerful power management which allows operation using efficiently 3V batteries.
- 1. Beacon module adopts Ble protocol, which can communicate with BLE module and smart mobile phone.
- 2. Farther than BLE distance.
- 3. Broadcast communication can be peer to pear, many-to-many, and there is no limit on the number.
- 4. SPI interface, without MCU on board, software and hardware technical support, low price.
| Parameters | Min. | Typ. | Max. | Unit | Condition |
| Working Condition | |||||
| Voltage range | 2.3 | 3.3 | 3.6 | V | |
| Operating Temperature | -40 | 25 | 85 | ℃ | |
| Current Consumption | |||||
| Rx current | 12 | mA | @3.3V | ||
| Tx current | 12.9 | mA | @3.3V | ||
| Sleep current | 20 | uA | |||
| RF Parameters | |||||
| Frequency range | 2.4 | 2.484 | GHz | ||
| Tx power | -18 | + 4 | dBm | @2.4V | |
| RF rate | 1M | bps | |||
| Special Function | Beacon |
Features of Beacon module Beacon128
- 3V battery
- Based on widely-spread, low-cost 26MHz quartz
- 1Mbps on-air data rate
- Programmable RF output level from -18dBm to +3dBm to optimize current consumption for a wide range of applications
- Supply Voltage Level Detector (SVLD) function enables monitoring the battery charge condition
Applications of Beacon module Beacon128
- Wireless Mouse
- Wireless health sports products
- commodity information push
- Remote control
- Alarm security system
- Wireless ranging system
| Pin NO. | Pin name | Description |
| 1 | VCC | Connected to the positive power supply (typical 5V) |
| 2 | GND | Connected to ground |
| 3 | TXD | TXD of the module and connect to external RXD |
| 4 | RXD | RXD of the module and connect to external TXD |
| 5 | SET | Configuration mode enable (low to enter into the setting mode, leave open or connect high level to exit setting mode) Valid when CS Pin is high or leave open. |
| 6 | CS | Module working Enable（Low level for sleep, current will be less than 40uA, default high level）. |
| 7 | NC | |
| 8 | GND | Connected to ground |
| 9 | GND | Connected to ground |
