LoRa610Pro : KC/ANATEL Certification 100mW Embedded Small Size Uart LoRa Module With ESD Protection

The LoRa module LoRa610pro is designed for 100mw output power and embedded small size design, which is widely used in wireless remote transmission control industries.
LoRa610Pro strictly uses lead-free process for production and testing, and meets RoHS and Reach standards.
Note: The LoRa Pro series can be configured to be compatible with our previous uart LoRa modules.
Hardware Features:
1. Small size.
2. Built-in hardware anti-crash self-reset circuit to resist strong external interference signals.
3. Overcurrent, overvoltage and reverse connection protection circuit.
Software Features:
1. AES128 data encryption.
2. LBT (Listen Before Talk).
3. Node/route/node+route optional in MESH mode.

DOWNLOAD

Note: The module is internally regulated by 3.3V LDO. The CS pin and SET pin control are 3.3V levels. TXD and RXD are also 3.3V levels.

Features of LoRa Module LoRa610Pro

NO.	PIN	Description
1	RXLED	Receive signal indicator, low level, default high
2	TXLED	Transmit signal indicator, low level, default high
3	CS	Module enable pin (built-in pull-up) Note: Default factory version: sleep current <200uA, CS pulled high or suspended for normal communication, sleep at low level; Low power consumption version: sleep current <15uA, normal communication when CS is pulled low, pull high or float to sleep.
4	RXD	Serial communication data reception
5	TXD	Serial communication data transmission
6	NC	No use
7	GND	Antenna Ground
8	ANT	RF signal output, connected to 50 ohm antenna
9	GND	Antenna Ground
10	+3.3V OUT	3.3V voltage output pin, can drive devices within 50mA
11	485EN	Can be connected to the external expansion 485 level control conversion pin
12	SET	Configuration parameter enable (low level enable parameter configuration, default high level output)
13	GND	Connect the negative pole of the power supply, ground wire
14	VCC	Connect the positive pole of the power supply (typically 5V)