English
Contact us
HOME > PRODUCTS > BLUETOOTH MODULES > BEACON600 : 2.4GHZ EMBEDDED UART BEACON MODULE
Beacon600 : 2.4GHz Embedded UART Beacon Module
- Beacon600 is the latest 2.4GHz beacon module which is compatible with BLE. This module integrates the MCU and process the SPI protocol. It provides generic UART interface, users can connect the module with smart phone with BLE. This module has the same structure of BLE, and works as Broadcast mode of Bluetooth. It is easier and cost-effective compare with Bluetooth.
- 1. Beacon module adopts Ble protocol, which can communicate with BLE module and smart mobile phone,
- 2. Farther than BLE distance,
- 3. Broadcast communication can be peer to pear, many-to-many, and there is no limit on the number.
- 4. Uart interface with MCU on board,transparent transmission. no need to debug and firmwaer writing.
| Parameters | Min. | Typ. | Max. | Unit | Condition |
| Working Condition | |||||
| Voltage range | 2.8 | 5.0 | 6.5 | V | |
| Operating Temperature | -40 | 25 | +85 | ℃ | |
| Current Consumption | |||||
| Rx current | 20 | mA | |||
| Tx current | 19 | mA | |||
| Sleep current | 11 | uA | |||
| RF Parameters | |||||
| Frequency range | 2.4 | - | 2.484 | GHz | |
| Serial baud rate | 1200 | 9600 | 115200 | bps | |
| Tx power | -18 | - | +3 | dBm | Configurable |
| Special Function | Beacon |
Features of Beacon Module Beacon600
- Communicate by the Bluetooth broadcasting mode and scanning mode.
- Serial transparent transmission, adjustable parameters
- 1M bps on-air data rate
- Output power up to +3 dBm
- Embedded and small size
- Low power consumption and cost-effective
Applications of Beacon Module Beacon600
- iBeacon or AltBeacon
- Wireless health sports products
- Commodity information push
- Wireless remote sensing
- Alarm security system
- Wireless ranging system
| Pin NO. | Pin name | Description |
| 1 | VCC | Connected to the positive power supply (typical 5V) |
| 2 | GND | Connected to ground |
| 3 | TXD | TXD of the module and connect to external RXD |
| 4 | RXD | RXD of the module and connect to external TXD |
| 5 | SET | Configuration mode enable (low to enter into the setting mode, leave open or connect high level to exit setting mode) Valid when CS Pin is high or leave open. |
| 6 | CS | Module working Enable（Low level for sleep, current will be less than 40uA, default Low level）. |
| 7 | NC | |
| 8 | GND | Connected to ground |
| 9 | GND | Connected to ground |
